Phytoremediation of industrial sludge using vegetation‐assisted dewatering

With the emergence of risk‐based corrective action decisions, there is interest in the use of more natural techniques that may be as protective as the traditional removal, landfill, or capping approaches for impoundment closure. The use of phytoremediation is one of the more promising techniques. This article presents the results of a three‐year field‐pilot phytoremediation study that involved the use of plants to enhance sludge dewatering at an inactive natural gas‐cracking wastewater lagoon. The dewatering was accompanied by contaminant reduction of benzene, toluene, xylene (BTX), and naphthalene concentrations to below the cleanup goals. Meanwhile, the concentration reductions of three or more ring polynuclear aromatic hydrocarbons (PAHs) varied between 30 percent and 60 percent, except for dibenz[a,h]anthracene. The residual PAHs in the sludge are not leaching. Parallel laboratory studies suggest a reduced PAH availability and mobility in the unsaturated zone sludge. © 2002 Wiley Periodicals, Inc.     

Studies on enhanced degradable plastics: 1. The geographic variability in outdoor lifetimes of enhanced photodegradable polyethylenes

Studies on three types of enhanced photodegradable polyethylenes showed tensile elongation at break to be a suitable parameter for assessing disintegration due to outdoor weathering. Disintegration rates varied greatly with exposure location, with Arizona the harshest environment and Washington and New Jersey the mildest. The rate of breakdown of the enhanced degradable polyethylenes relative to unmodified plastic was termed an enhancement factor. For the materials studied, average enhancement factors generally ranged from five to fifteen. The location-dependent variability in rate parameters can be mostly explained in terms of different average radiation levels and temperatures at these locations. A duplicate exposure protocol was developed to determine if the test data were complicated by short-term fluctuations in sunlight or temperature during exposure.     

CRITICAL EVALUATION OF CERTAIN METHODS OF UNSTEADY GROUNDWATER HYDRAULICS1

The basic theories and fundamental assumptions usually employed in the solution of unsteady groundwater flow problems are reviewed critically. The best known method of analysis for such problems is based on the Dupuit-Forchheimer approximation and leads to a nonlinear parabolic differential equation which is generally solved by linearization or numerical methods. The accuracy of the solution to this equation can be improved by use of a different approach which does not employ the Dupuit Forchheimer assumption, but rather is based on a semi-numerical solution of the Laplace equation for quasi-steady conditions. The actual unsteady process is replaced by a sequence of steady-state conditions, and it is assumed that the actual unsteady flow characteristics during a short time interval can be approximated by those associated with “average” steady state flow. The Laplace equation is solved by a semi-discretization method according to which the horizontal coordinate is divided into subintervals, while the vertical coordinate is maintained continuous. The proposed method is applied to a typical tile drainage problem, and, based on a comparison of calculated results with experimental data, the method is evaluated and practical conclusions regarding its applicability are advanced.     

Degradation of Polylactic Acid (PLA) Plastic in Costa Rican Soil and Iowa State University Compost Rows

In this study the degradation of polylactic acid (PLA) plastic films in Costa Rican soil and in a leaf composting environment was investigated. Three types of PLA films were used: Ch-I, (PLA monolayer plastic films from Chronopol, Golden, CO), GII (PLA trilayer plastic films from Cargill Dow Polymers LLC, Minnetonka, MN), and Ca-I (PLA monolayer plastic films from Cargill Dow Polymers LLC). The average soil temperature and moisture content in Costa Rica were 27°C and 80%, respectively. The average degradation rate of PLA plastic films in the soil of the banana field was 7675 M _w/week. Two compost rows were set up at the Iowa State University (ISU) (Ames) compost site. Temperature and relative humidity of the compost rows were kept at 55 ± 5°C and 50 ± 10% RH, respectively. The degradation rates of GII and Ca-I in the compost rows were 113,290 and 71,283 M _w/week, respectively. Therefore, it was estimated that in Costa Rican soil and in compost rows, PLA would be visibly degraded in 6 months and in 3 weeks, respectively.     

Development and validation of a method for analysis of "dioxin-like" PCBs in environmental samples from the steel industry

A method, previously used for determination of 2,3,7,8-substituted polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs), has been modified for quantitative analysis of "dioxin-like" polychlorobiphenyls (PCBs) in environmental samples from the steel industry. The existing sample clean-up procedure, involving liquid chromatography on multi-layered silica and Florisil columns, has been extended to include a third chromatography stage on a basic alumina stationary phase. The additional clean-up stage is required for PCB analysis in order to eliminate interferences from relatively large concentrations of saturated cyclic and aliphatic hydrocarbons. Samples were analysed for WHO-12 congeners using high resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) and standard solutions of the method US EPA 1668A. Replicate analysis of method blanks revealed background contamination for PCBs 118, 105 and 77, which are generally abundant in ambient air. These contaminants were taken into account using a subtraction method. The entire procedure was validated by replicate analysis (N = 3) of a certified reference sediment. The RSD for each WHO-12 congener was below 15%, 13C12-labelled PCB internal standard recoveries were in the range 70-95%. A waste dust sample collected in the electrostatic precipitator of a UK sinter plant was analysed for determination of PCDD/Fs and WHO-12 PCBs and exhibited a PCDD/F I-TEQ of 148.5 +/- 21.2 ngkg(-1) and a WHO-TEQ of 7.2 +/- 1.5 ngkg(-1). WHO-12 congeners contributed only 4.6% to the overall TEQ and PCB 126 was the major congener contributing to the WHO-TEQ (96%). The contribution to the overall TEQ of the waste dust sample was mainly attributed to PCDF followed by PCDD, which accounted for 86.6% and 8.7% to the overall TEQ, respectively.     

Graduated driver licensing and safer driving

Graduated Driver Licensing (GDL) inserts between the leaner permit and full licensure an intermediate or "provisional" license that allows novices to drive unsupervised but subject to provisions intended to reduce the risks that accompany entry into highway traffic. Introduction of GDL has been followed by lowered accident rates, resulting from both limiting exposure of novices to unsafe situations and by helping them to deal with them more safely. Sources of safer driving include extended learning, early intervention, contingent advancement, and multistage instruction. To extend the learning process, most GDL systems lengthen the duration of the learner phase and require a specified level of adult-supervised driving. Results indicate that extended learning can reduce accidents substantially if well structured and highly controlled. Early intervention with novice traffic violators have shown both a general deterrent effect upon novice violators facing suspension and a specific effect upon those who have experienced it. Making advancement to full licensure contingent upon a violation-free record when driving on the provisional license has also evidenced a reduction in accidents and violations during that phase of licensure. Multistage instruction attempts development of advanced skills only after novices have had a chance to master more basic skills. Although this element of GDL has yet to be evaluated, research indicates crash reduction is possible in situations where it does not increase exposure to risk. While the various elements of GDL have demonstrated potential benefit in enhancing the safety of novice drivers, considerable improvement in the nature and enforcement of GDL requirements is needed to realize that potential.     

The first commercial supercritical water oxidation sludge processing plant

Final disposal of sludge continues to be one of the more pressing problems for the wastewater treatment industry. Present regulations for municipal sludge have favored beneficial use, primarily in land application. However, several agencies and entities have warned of potential health risks associated with these methods. Hydrothermal oxidation provides an alternative method that addresses the health concerns associated with sludge disposal by completely converting all organic matter in the sludge to carbon dioxide, water, and other innocuous materials. A hydrothermal oxidation system using HydroProcessing, L.L.C.'s HydroSolids process has been installed at Harlingen, Texas to process up to 9.8 dry tons per day of sludge. Based on a literature review, this system is the largest hydrothermal oxidation system in the world, and the only one built specifically to process a sludge. Start up of Unit 1 of two units of the HTO system began in April 2001. Early results have indicated COD conversion rates in excess of 99.9%. Harlingen Waterworks System estimates that the HydroSolids system will cost less than other alternatives such as autothermal thermophilic aerobic digestion and more traditional forms of digestion that still require dewatering and final disposal. The Waterworks intends to generate income from the sale of energy in the form of hot water and the use of carbon dioxide from the HydroSolids process for neutralization of high pH industrial effluent. The Waterworks also expects to generate income from the treatment of septage and grease trap wastes.     

Response of Ceriodaphnia dubia to ionic silver: discrepancies among model predictions, measured concentrations and mortality

Silver thiosulfate, often a waste product of photoprocessing, is less bioavailable or toxic to aquatic organisms than is ionic silver. We conducted duplicate 48-h Ceriodaphnia dubia tests in reconstituted laboratory water using treatments of 92.7 nM Ag+ with various concentrations of thiosulfate. Expected Ag+ concentrations were generated for thiosulfate treatment levels using MINEQL + chemical equilibrium modeling. Ag+ concentrations in treatments were determined using a novel silicon-based sensor. Based on predicted Ag+ and published 48-h LC50 values for C. dubia, we did not expect to observe adverse effects. Yet, 100% mortality was observed at low thiosulfate treatments, whereas > 85% and > 95% survival was observed at higher thiosulfate treatment levels, respectively. Our results indicate that biotic responses match the sensor-based Ag+ concentrations. However, there is a discrepancy between these empirical results and responses expected to occur with Ag+ concentrations as predicted by MINEQL + chemical modeling. By correlating silicon sensor data with toxicity results obtained from our laboratory, our work clearly relates a specific chemical form (Ag+) to toxicity results.